Baja tahan karat
Koil Baja Tahan Karat Canai Panas
Koil canai panas anil dan pickling No.1 dalam 304 / 316L / 2205 — 3–12 mm, lebar hingga 1500 mm.
3–12 mmKetebalan
≤ 1500 mmLebar
Spesifikasi tersedia
| Grade | Ketebalan | Lebar / diameter | Standar |
|---|---|---|---|
| 304 · 316L · 2205 | 3–12 mm | ≤ 1500 mm | ASTM A240 / EN 10088-2 |
Rentang yang ditampilkan adalah ketersediaan standar; ukuran non-standar dapat dibuat sesuai pesanan. Ketebalan bersifat nominal — toleransi dinilai berdasarkan ASTM A480 / EN 10088-2.
Aplikasi umum
- Komponen struktural dan pendukung
- Cangkang tangki dan bejana besar
- Substrat untuk pengerolan dingin lebih lanjut
Pengiriman dan inspeksi
- Dianil penuh dan dipikel, residu asam dibilas — residu asam muncul sebagai garis karat beberapa bulan kemudian
- Catatan pasivasi tersedia atas permintaan
- Kondisi tepi: tepi gilingan atau dipangkas
Butuh penawaran atau dukungan teknis?
Kirimkan grade, ukuran, kuantitas, dan pelabuhan tujuan — kami membalas dengan FOB / CIF dalam 24 jam.
Typical applications
Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.
- Chemical plant — tank shells, reactor jackets, pipe supports
- Water and environment — waste water basin liners, desulphurisation towers, desalination lines
- Industrial structures — walkways, silos, conveyor frames
- Power — flue ducts, heat recovery units
- Further processing — feedstock for cold rolling, or decoiled into plate
Selection FAQ
- Can No.1 finish be used as-is?
- Yes, but it is grey and rougher. Visible structural parts are usually pickled or brushed afterwards.
- Hot rolled or cold rolled coil?
- Thicker material (generally above 3 mm), strength first, appearance secondary — hot rolled. Thin gauge, tight tolerance, good surface — cold rolled.
Not sure which grade fits? Use the grade selector