Baja tahan karat
Strip Stainless Belah
Strip belah dalam 304 / 316L / 430 — lebar dari 8 mm, ketebalan 0,3–3 mm, geram terkendali untuk stamping.
0,3–3 mmKetebalan
8–1500 mmLebar
Spesifikasi tersedia
| Grade | Ketebalan | Lebar / diameter | Standar |
|---|---|---|---|
| 304 · 316L · 430 | 0,3–3 mm | 8–1500 mm | ASTM A240 / EN 10088-2 |
Rentang yang ditampilkan adalah ketersediaan standar; ukuran non-standar dapat dibuat sesuai pesanan. Ketebalan bersifat nominal — toleransi dinilai berdasarkan ASTM A480 / EN 10088-2.
Aplikasi umum
- Bagian stamping sempit
- Pembuatan tabung dan pipa
- Klem selang dan pengencang
Pengiriman dan inspeksi
- Tinggi geram ≤ 0,05 mm sesuai permintaan (penting untuk stamping berkecepatan tinggi)
- Kondisi tepi: digulung atau dihilangkan geramnya
- Catatan: di bawah lebar 100 mm kehilangan akibat pemotongan mencapai 3–5% — kami mengutip hasil rendemen
Butuh penawaran atau dukungan teknis?
Kirimkan grade, ukuran, jumlah, dan pelabuhan tujuan — kami membalas dengan FOB / CIF dalam 24 jam.
Typical applications
Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.
- Tube making — welded tube, decorative tube, heat exchanger tube strip
- Stamping — cookware, locks, hardware blanks
- Cable tray and brackets — continuous roll-formed strip
- Automotive — clamps, trim strips, seal carriers
- Electronics — spring contacts, shields, battery shells
Selection FAQ
- What is the narrowest slit width?
- 8 mm is standard. Narrower needs an assessment of edge burr and coil winding quality — tell us the application when enquiring.
- What burr height do you hold?
- Within 0.05 mm as standard. For stamping or blanking, tighter limits can be agreed in the order.
Not sure which grade fits? Use the grade selector